Destination 4x4 - Artec Industries

NOTE: If your lift replaces your track bar and mounts to the factory axle bracket (typical with a lift that includes an adjustable track bar), choose FACTORY HEIGHT BRACKET. If you are doing a DRAG LINK FLIP (which requires a minimum 3" lift and bump stop extensions), choose RAISED HEIGHT BRACKET. Features include:

• 1/4" and 10 gauge (.130") mild steel. Precision CNC cut and bent for great fitment.
• Truss is low profile to allow clearance above the axle.
• Truss spans length of long side AND short side.
• Truss is reinforced using interlocked 10 gauge thick gussets for maximum strength and easy assembly.
• Overall low profile design means your axle is stronger, sleeker, easier to fit into any vehicle, and less likely to interfere with vehicle components.
• 1/4" thick CNC laser cut and bent knuckle gussets, LCA skids, and HD Track bar bracket ensure easy install to replace or reinforce those weak factory components.

THIS KIT IS INTENDED FOR VEHICLES WITH AT LEAST MINOR LIFTS. IF USING WITH NO LIFT, CHECK CLEARANCES BEFORE INSTALLING. NOT TESTED IN NON-US JKs WITH DIESEL ENGINES or RIGHT HAND DRIVE AXLES. NOTE: This kit requires general welding and fabrication skills including welding to the cast center section and cast inner c's. Welding should only be done by a competent welder. Artec Industries implies no guarantees or warranties and is not liable for improper installation. Some grinding and fitment may be required when installing this kit. Every axle varies slightly and some fabrication may be required. In rare and extreme cases, the truss may come into contact with oil pan. Prior to operating the vehicle, remove the coil springs, cycle the suspension including full compression of both sides simultaneously and add bump stop extensions to prevent damage to oil pan.

Features include:

• 1/4" and 10 gauge (.130") mild steel. Precision CNC cut and bent for great fitment.
• Truss is low profile to allow clearance above the axle.
• Truss spans length of long side AND short side.
• Truss is reinforced using interlocked 10 gauge thick gussets for maximum strength and easy assembly.
• Overall low profile design means your axle is stronger, sleeker, easier to fit into any vehicle, and less likely to interfere with vehicle components.

THIS KIT IS INTENDED FOR VEHICLES WITH AT LEAST MINOR LIFTS. IF USING WITH NO LIFT, CHECK CLEARANCES BEFORE INSTALLING. NOT TESTED IN NON-US JKs WITH DIESEL ENGINES or RIGHT HAND DRIVE AXLES. NOTE: This kit requires general welding and fabrication skills including welding to the cast center section. Welding should only be done by a competent welder. Artec Industries implies no guarantees or warranties and is not liable for improper installation. Some grinding and fitment may be required when installing this kit. Every axle varies slightly and some fabrication may be required. In rare and extreme cases, the truss may come into contact with oil pan. Prior to operating the vehicle, remove the coil springs, cycle the suspension including full compression of both sides simultaneously and add bump stop extensions to prevent damage to oil pan.

Features include:

• 1/4" and 10ga. thick mild steel truss. Precision CNC cut and bent for great fitment.
• Truss is low profile allowing ideal mounting height of an aftermarket 3 link suspension system, if desired.
• Truss spans entire length between spring buckets, aprox. 26.5"
• Truss is reinforced using interlocked 10 Ga. thick dimple died gussets for maximum strength and easy assembly.
• Overall low profile design means your axle is stronger, sleeker, and less likely to interfere with vehicle components.

NOTE: This kit requires general welding and fabrication skills. Welding should only be done by a competent welder. Artec Industries implies no guarantees or warranties and is not liable for improper installation. Some grinding and fitment may be required when installing this kit. Every axle varies slightly and some fabrication may be required. May require brake line relocation to fit.